Electric scooters are great possessions, not until your charge runs out in a remote location. That is when you will wish you knew better and opted for a diesel-powered one. However, this ought not to be so much of an issue. It is indeed possible to utilize an electric scooter in a distant location without worrying about what to do when the charge depletes.
This is because it is indeed possible to charge the vehicle without using the ordinary power outlets. In our discussions below, we are going to look into the two main options that may help you out.
In Case you are yet to buy an electric scooter, visit joinfuse.com for some great reviews.
Option 1: Using a Portable Car Jumper
This is basically a portable battery which holds higher voltage than the normal batteries. To charge your electric scooter using this technique, follow the procedures below:
Step 1: Attach the Jumper to your Scooter’s Battery
Start by attaching the jumper to the battery of your scooter. Connect the red wire to the positive terminal and the black wire to the negative terminal. Be sure that there are no leaks or breaks in the connections as these may to you to danger.
Resist the temptation of attaching other devices onto the jumper as this may drain the current and render your charge of no effect.
Step 2: Turn the Jumper On
Switch the jumper on. This is to trigger the flow of current from the jumper to the battery. It is this flow of current that will eventually charge your scooter’s battery.
Step 3: Leave to Charge
Leave the connection for around 20 minutes for the battery to fully charge. Do not disconnect the jumper from the battery before the 20-minute duration is complete.
Such a disruption may damage your battery. It may also subject you to the risks of electrocution or even electrical fires.
Step 4: Check the Battery Levels
After the 20 minutes have elapsed, check the level of your scooter’s battery. In case it is not fully charged, you may wish to leave the connection intact for quite some time.
Step 5: Disconnect the Jumper
Once the battery is fully charged, disconnect it from the jumper. Do so by unplugging the negative terminal of the jumper from the battery. Proceed thereafter to unplug the positive terminal. You are now free to test the ride and go!
Option 2: Utilizing a Universal Power Adapter
The universal power adapter is an electronic device that has the ability to store up electrical charge for some time. It is also superior to most other electronics of its kind in that it is compatible with as many devices as possible.
You will, therefore, most likely find it suited to your unique situation. To charge the battery of your scooter, follow the procedures below:
Step 1: Plug your Power Cable to Adapter
The adapter as stated can accommodate different kinds of devices. You will thus be certain that at least one of the connecting wires can fit your port.
Find this specific one and connect it to the port of your batter. Plug it in tightly to avoid any leakages that may render some loss of power.
Step 2: Switch off your Scooter’s Power
Now proceed to switch off your scooter’s power outlets. Switch off the radio, lights, and any other component of the scooter that may be drawing power. This is to expedite the process of charging and reduce the wastage of energy.
Step 3: Leave to Charge
Leave the battery to charge for some time. The universal adapter stores up less voltage than its car jumper counterpart.
For this reason, you will not have to wait for too long as is the case with the car jumper above. Do not, therefore, wait for the battery to fully charge before disconnecting.
Step 4: Disconnect when Done
As soon as the charge is depleted, unplug the power cable and start the scooter.
PS: This second option is a stop-gap measure in the sense that it only helps you to navigate a difficult situation. It does not at all provide a permanent or long-lasting solution to your power problem.
CLOSING REMARKS
As you may see, this feat can be accomplished. The various options are however not so reliable, especially in the long run. You still have to find a permanent solution to the issue to avoid encountering unnecessary inconveniences.
